Yeah that’s a good choice…
You’ll probably need to cut off the length you need and then rip it in half down the middle, should fit snug in the coil with some resistance when you pull on it…
2 Likes
I generally cut the cotton tails flush with the bottom of the deck:
Then you can comb and fluff the cotton if preferred, I don’t myself, tuck the cotton into the juice wells and drip with e-liquid until saturated.
4 Likes
Excellent stuff rocky can’t wait to give this all a go just waiting for coils and rda to come as I ordered new tengu for 5quid about 6dollar
2 Likes
So while waiting for the new Rda to come in the post I removed an old coil and put it back in to practice a little bit and put some jap cotton through
Can’t wait for coils to come and other Rda to get it set up 
4 Likes
Rda turned up today still waiting for alien coils put in Clapton coils in put enough cotton in that I can just about move the cotton side to side but without moving the coil itself I made sure inside to outside glow
took awhile to get it that way just keep squeezing the coil with ceramic tweezers and strumming the coil too finally boom perfect wicked her up juiced the coil well and cotton before tucking and boom delicious flavour and cloud :)
3 Likes