Wotofo Nexpod refilling empty pod

Ok so i got empty pods and they are simple to dismantle. Was shocked how easy it was. So firstly lets begin shall we their is a upper notch on the bottom plate


Take a pointy knife gently press in between the cap and the body of the pod. Be careful when doing this.(safety first) probably could use a very small flat head to do this. But i broke mine a while back

Once you push down the cap moves down.

Now you need to place the knife on the edge and push it down

Once its off remove the connecting plate for the leads of the coil


Move the leads upright to pull the rubber gasket out of the way and thats it.

You can refill your empty pod with anything you want. Hope this helps the people that bought the nexpod. And by refilling them there is now less waste from them

11 Likes

I have all 18 flavors, I haven’t even vaped through 1 yet. I’ve tried them all though. All good flavors for a stealth vape at work for sure.

5 Likes

Love seeing stuff like this. Thanks for sharing!

6 Likes

Bonus to selling this to a friend, i got to finally try them. I can say that majority were not that great. Out of the 18 i only liked 4. The cooling effect ruins a lot of the flavors. Just too much cooling on most. Id never buy the kit. Even If i was into pods i wouldnt buy it. There are better options and less expensive ones. Overall i wasnt impressed with it. It might of been different if their was no cooling effect on every flavor. But i wouldnt recommend it.

5 Likes

Well, fortunately for me they are very convenient for vaping at work. I’d never buy it, it was sent to me by Wotofo for beta testing for the US.

3 Likes

Its all its good for is discreet vaping but other disposables do the same and are cheaper

4 Likes

Totally agree there. I honestly wouldn’t normally vape them, but they send them. Even if I wanted to replace a flavor, it’s way too much money!

4 Likes

If they really wanted this whole kit to work they needed to bring the price point down and make the cartridges available on a place other then their website. And decided not to put cooling effect in everything. But my honest opinion they wasted their time with it. I cant see it being around long thats for sure.

3 Likes

So i took it all a part today and took the cotton strands out of it and all that was wrapped around was two leads. So i put a strand of the muji in it wrapped and stuffed where it was snug put the foam around it and filled it. Now the previous flavor profile is gone. Worked like a charm. Literally no coil at all just two two leads im literally shocked. So much for nex mesh in it :joy::joy::joy:

3 Likes

You sir are cheaper than I am. ,:joy: Right now I’m vaping on my WOTOFO Rebuildable coils. Used their mesh that I cleaned up (used) and wrapped with my Japanese cotton that was too short to rebuild my RTA’s. ,:clap::clap::clap:

4 Likes

So i did another two and yes there was mesh. So yes i crushed the mesh thats why it appeared two leads lol. It still worked. I did another two pods. Refilled and recottoned and are good as old. Just need to be careful pulling it out but totally rebuidable. I lost two out of 5 the first and second pod but its a learning curve. But i have now giving him 3 pods redone and filled

4 Likes

Its my buddy who is cheap he doesnt want to spend the money on the pods and for me it was hey lets see if i can do it and i did but me me being me was just too violent with the first two. I had patience the last 3. Those mesh in these will last real long cause its low wattage.

4 Likes