A little something different. 3 strands 26g Kanthal fused and fused again to 2 strands twisted 317L. I’m going for a staged heated fused clapton. The fused kanthal should fire slow and the twisted 317L should fire like a rocket. Seven strands total, about 15+ ft of wire. The glowshot should be a light show.
All this twisting and fusing you’re doing with these wires has me thinking about trying a 3 strand twist of 24g Kanthal, 24g NiCr80 and 25g 317L.
I might have a go at that later.
I had a hommer Simpson moment last night.
Was about to install a mostly Nichrome Transformer coil in my Petri and thought these posts have been leaning like the Pisa so I tried straightening out one. Snap. Off it came from the deck. Lol.
Straight onto FT for another I went and decided to add on a Velocity too.
With what you’re building, anything under 100w is gonna struggle to keep up. You need two good 18650s to jump those builds off. The better your builds get , the more power will need… and like me you’re gonna see your ohms get lower and lower. You are out building your hardware. Consider a 100w plus dual 18650 mod.
I think eventually I’ll probably end up with the SnowWolf200 as my high wattage Mod but for now my M80 (shipping tomorrow) will suffice for my delve into regulated Sub Ohm vaping.
Have you checked out RipTrippers sneak peak at the DNA200 box???
Alright Coil Boys…here’s what I’ve got so far: Ni200 in 28, 30, 32; Tempered Ni200 in 30; Kanthal A1 in 24, 26, 28, and 32; and SS 316L in 26. Two questions: What should I get next? Considering I have a single batt 50w box with finicky TC, a Magma, a PV 1.5, and NO drill, where should I start?
Eh, whatever isn’t going to burn through my batteries in 20 mins cuz I only have two right now. LoL. The lowest I’ve gone so far is 0.5. Don’t think I’ll be doing any sub sub ohming any time soon, but other than that, I’m open to suggestions.
It’s going to be hard to keep the Ni200 and the 316L above .5… you would have to do a single coil build with a 2.5 or more inner diameter with 8 or more wraps to stay above .5 ohms. If you use TC the low ohms wouldn’t matter because u can turn ur temp down.