Updated firmware from v1.080 to v1.093, and had some trial and error with the app.
I’ve got a decent grasp on it for the most part, TC-SS, DC, and I’ve messed around with the coefficient…but I need help.
For starters what tco should I be at with 316L?
And now here’s my situation: I’ve got my temp set at 450°f but I’m not seeing any temp above 177°f…I see it go into temp protection, I get 2 decent puffs and then I get dumped into wattage mode, and sometimes I get a check atomizer error.
Help me out here, please, i know I’m getting close.
[edit] I’m waiting for my atomizer to cool, and then I’m going to lock in the resistance (just remembered/found that).
Default for SS, I believe. Set it to 0.001 - then try to adjust your ohms. That’s what I found worked for me. If it protects too early, try adjusting the ohms to be a bit higher… OTOH since it kicks you to wattage mode, try lowering the ohms - that’s what works on my Koopor Plus.
3 Likes
Meh it’s a bust for today, I just can’t get it to work with this build.
At some points my resistance was as high as 2.8 and all over the place in between.
I’d let it cool to room temp and it’d read .87, bump it again .39…just madness.
I decided to build up some new Goblins for my friends and make juice.
My patience will pay off.
1 Like