I have multiple mesh RTA’s. Different manufacturer. I wick them all the same way and haven’t had any weeping since I watched this. The cotton ears on top give it a better vape. It is all in the cut.
3 Likes
thanx. how close together are the coils ?
2 Likes
I always use contact coils.
1 Like
@jinx_d, granted this is the original SteamCrave RDTA v.1 with the Velocity deck, but every chance I get, I run dual verticals, 24ga. Kanthal, 7 wrap, 3mm I.D.
3 Likes
Session drummer thanks that you mentioned pg vg ratio maybe that is little nicer if i mix my juice in little higher pg ratio i always vape at 20/80 maybe the juice flow gets more wett and suck it up better
2 Likes
@min0, I’m not sure where you’re located, but currently on the East Coast US, it’s damned cold. Sometimes I back down my daily drivers from 70v/30p, to 60v/40p just due to the thickening of the liquid while out and about. Your PG sensitivity will however dictate how low you can go. Obviously if you go TOO low, hehe weeping can occur. Just a balancing act, and it CAN vary from setup to setup.
My experience with the bigger (more recent) SteamCraves, is the juice flow ports are ginormous !!!. When I’ve filled them (with the juice and airflow closed), closed the tank, and opened up the juiceflow, I can almost hear a GLUG GLUG as it’s pre-charging !!!
1 Like
Nice verts!. Looks like a clean build…
2 Likes
Okey session drummer:) what is wheeping?
2 Likes
slight leaking
1 Like
How low can i go whitout leaking is 70vg 30pg good?
1 Like
Can i go vertikal on my aromamizer plus rdta? Is it better flavor?
2 Likes
that depends. typically your wicking controls leaking = not enough, whatever that may be. but its not all that simple, many factors.
2 Likes
Weeping is when you’re mix starts leaking through the holes of the air intake. It happens when a Steam crave tank is over filled. In the instructions it tells you to fully open the juice adjustment control and turn upside down to empty the lower chamber(coil & wicking). Close the flow adjustments and return to upright. Remove filling cap and fill and replace cap. I open the flow adjustment half way. I guess it’s a liquid seeks it’s own level kind of thing to keep it from flooding. It leaves about a 1/4" space under the fill cap.
3 Likes
ok. mine is built and working. waiting for it to sort itself out.
2 Likes
well. its not leaking = YEAY !!! but flavor is crap, nonexistent. tastes like cotton, and i used rayon.
3 Likes
yeah. but what. i wish i knew a local experienced vaper that could help me troubleshoot first hand. idk if its me, my stuff, or both. i’m thinking about mixing a small bottle of 40/60 pg/vg and see what happens.
2 Likes
@jinx_d, ok I never use rayon, and can’t compare my results with cotton vs. yours. Do you have any cotton to use, so we can rule that out ? What exact coils are you using, and wattage. Can you take pics of your exact setup, so we can see where the coils are in relation to the airflow (makes a big difference), spacing, wicking, etc. ?
2 Likes
you should try rayon, its more neutral than cotton, at least initially.
i have cotton, doesn’t make a difference in other atty’s.
2 core sfc’s. pics soon.
small bottle of 40/60 is made.
2 Likes